CF Moto V3/V5 Performance Exhaust
These are sold out again, MRP is the only company that makes the pipe and they make very little of them. None for 2014 were produced.
No worries. Straight Up Performance along with Scoot Power which Scootertronics is part of the Straight Up Performance Family makes custom header pipes to install Helix and EMGO exhaust.
The header pipes is the most important part. A custom header is made from 1/2 stainless steel exhaust header pipe. A flange is attached that floats, this makes it much easier to install. Depending on upgrades that are being to the carb and air filter will effect the making of a custom header.
The Helix Megaphone Exhaust can is the best with the EMGO being louder. These are the same exhaust used on the Cleveland Cyclewerks Tha Misfit and Heist with great success. The header pipes are wrapped in either black or tan exhaust wrap. You may also have pipe chrome coated on your own or leave naked for raw look. The wrap serves two purposes. Contains heat making engine cooler and also help keep engine temp at best level for performance.
Your new custom exhaust exhaust comes with all hardware to install. 8mm studs and nuts are included. The mounting bracket can be used and attached to shock mount although pipe holds fine without.
Please email or call for your custom CF Moto exhaust 240 377 8719 Estimate Cost 149.99 - 299.99
These have shipped to customers who ordered plus there are still a few more left they will not last.
These are a shorter and smaller exhaust can with same header and a great sound, the low tone is all there along with the performance. I do suggest an air filter up to a new carb for best performance from V3 or V5.
Comes complete with clamps and brackett, one clamp does come close to logo but does not affect.
The best performance with this exhaust is when you combine weights, Malossi or Athena belt plus Torque spring and CDI this will unleash the power.
When used with the 32mm carb set up the HP and top speed go up to speeds of 80mph and easy speeds of 70/75 all the time.
This pipe is it. Sounds great and adds great pick up and top end by opening up exhaust which is held back by stock exhaust. Adding an Uni Pod filter will also help even more.
MRP-PIPE V3-250CC- RACING PIPE V3/V5 250 CN 250 #27364
MRP-PIPE V3-250CC- RACING PIPE V3/V5 250 CN 250
Pipe makes a diiference for bottom and top end speeds, this mod plus a clutch and Dr Pully roller weights does the trick.
Works on engines 172mm used on most 250cc scooters out today plus 250cc carts should be able to use this pipe also.
This pipe does come in a shorter version to install on many CN250 scooters for the best upgrade a scooter can get with high performance exhaust.
48 Lower States Only